Activation Character; End Character Activation After Good Read - Honeywell HF680 Series User Manual

following On barcode to use character activation, then use Activation Character
(following) to select the character you will send from the host to start scanning.
Default = Off.

Activation Character

This sets the character used to trigger scanning when using Character Activation
Mode. On the
represents the character you want to use to trigger scanning. Scan the following
barcode, then use the
that represents that ASCII character. Scan Save to finish.

End Character Activation After Good Read

After a barcode is successfully detected and read from the scanner, the aimer can
be programmed either to remain on and scanning, or to turn off. When End
Character Activation After Good Read is enabled, the aimer turns off and stops
scanning after a good read. If you scan Do Not End Character Activation After
Good Read, the aimer remains on after a good read. Default = End Character
Activation After Good Read.
Activation After Good Read
HF680 Series User Guide
* Off
ASCII Conversion Chart (Code Page
Programming Chart
Do Not End Character
1252), find the hex value that
to read the alphanumeric combination
Activation Character
On
* End Character Activation
After Good Read
41