Table of Contents
Advertisement
AE00124
Engine switch
The engine switch controls the ignition system.
1
1 "7" (ON)
Ignition circuit is switched on.
2
The engine can be started.
763-259
2 "5" (STOP)
Ignition circuit is switched off.
The engine will not run.
AE00111
Oil warning light (red)
When the oil level falls below the lower level, the oil
warning light (red) comes on and then the engine
stops automatically. Unless you refill with oil, the
engine will not start again.
TIP
If the engine stalls or does not start, turn the engine
switch to "7" (ON) and then pull the recoil starter. If
the oil warning light flickers for a few seconds, the
engine oil is insufficient. Add oil and restart.
700-121
DC protector
The DC protector turns to "
when electric device being connected to the generator
is operating and current above the rated flows. To use
this equipment again, turn on the DC protector by
763-260
pressing its button to "
1 "
Direct current is output. (This is the default position.)
2
2 "
1
Direct current is not output.
763-238a
NOTICE
Reduce the load of the connected electric device
below the specified rated output of the generator
if the DC protector turns off. If the DC protector
turns off again, stop using the device immediately
and consult a Yamaha dealer.
I" (ON)
3" (OFF)
– 8 –
3" (OFF) automatically
I" (ON).
Advertisement
Table of Contents
