Honeywell HDS18SS User Manual page 8

Getting Started
01 Load the dishwasher. (See Dish Preparation and Loading sections)
02 Add detergent. (See Filling the Detergent Dispenser)
03 Add rinse aid. (See Filling the Rinse Aid Dispenser)
04 Select desired CYCLE. (See Cycle Chart)
05 Select desired OPTIONS (See Control Panel). The indicator light above the pad will
glow when selected.
06 Run the hot water faucet nearest the dishwasher until the water is hot, then turn it
off.
07 To start, press Start/Cancel. (See Control Panel) Then close door.
NOTE This model is embedded operation, all buttons can only be operated in the
open state.
Wash Cycle Selections
Cycle times are approximate and will vary with the options selected. Hot water is
necessary to activate the detergent and melt fatty food soils. An automatic sensor
will check the incoming water temperature. If it is not at the appropriate temperature
the timer will delay the cycle to allow automatic water heating during the main wash.
When the HI-TEMP wash is selected an even higher temperature will be assured to
handle heavier soil loads.
6