Advertisement
Limitations of this Wireless Alarm System, Continued
This system's wireless transmitters are designed to provide long battery life
under normal operating conditions. Longevity of batteries may be as much
as 7 years, depending on the environment, usage, and the specific wireless
device being used. External factors such as humidity, high or low
temperatures, as well as large swings in temperature, may all reduce the
actual battery life in a given installation. This wireless system, however, can
identify a true low battery situation, thus allowing time to arrange a change
of battery to maintain protection for that given point within the system.
Installing an alarm system may make the owner eligible for a lower
insurance rate, but an alarm system is not a substitute for insurance.
Homeowners, property owners and renters should continue to act prudently
in protecting themselves and continue to insure their lives and property.
We continue to develop new and improved protection devices. Users
of alarm systems owe it to themselves and their loved ones to learn
about these developments.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This equipment has been tested to FCC requirements and has been found
acceptable for use. The FCC requires the following statement for your
information: This equipment generates and uses radio frequency energy and if
not installed and used properly, that is, in strict accordance with the
manufacturer's instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a Class
B computing device in accordance with the specifications in Part 15 of FCC
Rules, which are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated.
• Move the radio or television receiver away from the receiver/control.
• Move the antenna leads away from any wire runs to the receiver/control.
• Plug the receiver/control into a different outlet so that it and the radio or
television receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions. The user or installer may find the
following booklet prepared by the Federal Communications Commission helpful:
"Interference Handbook". This booklet is available under Stock No. 004-000-
00450-7 from the U.S. Government Printing Office, Washington, DC 20402.
The user shall not make any changes or modifications to the equipment unless
authorized by the Installation and Setup Guide or User Guide. Unauthorized
changes or modifications could void the user's authority to operate the
equipment.
NOTE: WHEN CIRCUIT BOARD IS
MOUNTED IN CONTROL'S CABINET,
GROUNDING LUGS (2) PROVIDED
MUST BE INSERTED IN LEFT-HAND
TERMINALS OF ANTENNA BLOCKS
AND SECURED TO CABINET (SEE
RECEIVER'S AND CONTROL'S
INSTRUCTIONS). WHEN BOARD IS
MOUNTED IN A SEPARATE
CABINET (COMMERCIAL FIRE
APPLICATION), DO NOT USE THE
GROUNDING LUGS.
TO RELEASE CIRCUIT BOARD,
BEND BACK BOTTOM TABS (2). FOR
COMMERCIAL FIRE APPLICATION.
USE TWO SCREWS (NOT
SUPPLIED) WITH INSULATING
WASHERS BENEATH THE HEADS.
TO MOUNT BOARD IN SEPARATE
CABINET. (SEE RECEIVER'S
INSTRUCTIONS).
¬19l
N7635-3V3 1/01 Rev. C
ANTENNAS
CIRCUIT
INSERT IN
BOARD
RIGHT-HAND
TERMINALS
5881EN SERIES
MOUNTING HOLES
DIP SWITCH
GREEN LED: NORMALLY OFF
ONE SHORT FLASH - RF MESSAGE DECODED
ONE LONGER FLASH - COMMAND RECEIVED FROM CONTROL
FOUR FLASHES - ENCRYPTED TRANSMITTER SUCCESSFULLY ENROLLED
WWW.DIYALARMFORUM.COM
Honeywell International Inc., acting through its Security & Custom
Electronics business ("Seller") 165 Eileen Way, Syosset, New York 11791,
warrants its product(s) to be in conformance with its own plans and
specifications and to be free from defects in materials and workmanship
under normal use and service for 24 months from the date stamp control on
the product(s) or, for product(s) not having a manufacturer's date stamp, for
12 months from date of original purchase unless the installation instructions
or catalog sets forth a shorter period, in which case the shorter period shall
apply. Seller's obligation shall be limited to repairing or replacing, at its
option, free of charge for materials or labor, any product(s) which is proved
not in compliance with Seller's specifications or proves defective in materials
or workmanship under normal use and service. Seller shall have no
obligation under this Limited Warranty or otherwise if the product(s) is
altered or improperly repaired or serviced by anyone other than Honeywell
factory service. For warranty service, return product(s) transportation
prepaid, to Honeywell Factory Service, 165 Eileen Way, Syosset, New York
11791. THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF
MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE OR
OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE
HEREOF. IN NO CASE SHALL SELLER BE LIABLE TO ANYONE FOR ANY
CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR
ANY OTHER WARRANTY, EXPRESS OR IMPLIED, OR UPON ANY OTHER
BASIS OF LIABILITY WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS
CAUSED BY THE SELLER'S OWN NEGLIGENCE OR FAULT. Seller does not
represent that the product(s) it sells may not be compromised or
circumvented; that the product(s) will prevent any personal injury or
property loss by burglary, robbery, fire or otherwise; or that the product(s)
will in all cases provide adequate warning or protection. Customer
understands that a properly installed and maintained alarm system may
only reduce the risk of a burglary, robbery, fire, or other events occurring
without providing an alarm, but it is not insurance or a guarantee that such
will not occur or that there will be no personal injury or property loss as a
result. CONSEQUENTLY, SELLER SHALL HAVE NO LIABILITY FOR
ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER LOSS
BASED ON A CLAIM THAT THE PRODUCT(S) FAILED TO GIVE
WARNING. HOWEVER, IF SELLER IS HELD LIABLE, WHETHER
DIRECTLY OR INDIRECTLY, FOR ANY LOSS OR DAMAGE ARISING
UNDER THIS LIMITED WARRANTY OR OTHERWISE, REGARDLESS OF
CAUSE OR ORIGIN, SELLER'S MAXIMUM LIABILITY SHALL NOT IN
ANY CASE EXCEED THE PURCHASE PRICE OF THE PRODUCT(S),
WHICH SHALL BE THE COMPLETE AND EXCLUSIVE REMEDY
AGAINST SELLER. This warranty replaces any previous warranties and is
the only warranty made by Seller on this product(s). No increase or
alteration, written or verbal, of the obligations of this Limited Warranty is
authorized.
USE MAX. OF 220 ft. (67m) OF #22 (0.64mm) WIRE
OR 550 ft. (168m) OF #18 (1mm) WIRE FOR EACH RUN.
20 ft. MAX. IN COMMERCIAL FIRE INSTALLATIONS.
(SEE RECEIVER'S INSTRUCTIONS).
YELLOW
RED
BLACK
GREEN
5881ENL
WIRING
5881ENM
OPENING
5881ENH
PLUG & SOCKET
5881ENHC
FRONT OF PC BOARD
BACK OF PC BOARD
DETAIL A
SEE
INTERFERENCE
FRONT AND
DETAIL A
INDICATOR LED
REAR TAMPER
5881ENHC ONLY
165 Eileen Way, Syosset, New York 11791
Copyright © 2004 Honeywell International, Inc.
www.honeywell.com/security
LIMITED WARRANTY
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
FCC ID CFS8DL5882A
TO CONTROL'S KEYPAD
CANADA:17481021751A
TERMINALS. EACH RECEIVER
MUST BE ON INDIVIDUAL
HOME RUN.
DIP SWITCH #5
ON:
FOR USE IN COMMERCIAL FIRE APPLICATIONS.
(SEE THE RECEIVER'S INSTRUCTIONS).
OFF:
USE IN NON-COMMERCIAL FIRE INSTALLATIONS.
DIP SWITCH: WHITE AREAS = SWITCH HANDLES
POSITION 2-4: DETERMINE RECEIVER'S ADDRESS
CONSULT CONTROL'S INSTRUCTIONS FOR ADDRESS TO USE.
DIP SWITCH BELOW SHOWN SET FOR ADDRESS "0".
SWITCH
POSITION
ON
OFF
0
5
5
4
4
—
3
3
—
2
2
—
1
1
RECEIVER ADDRESS SETTINGS
("—" means "OFF")
1
2
3
4
5
6
7
(SEE TEXT ABOVE)
ON —
ON —
ON —
O N
ON ON —
ON ON
—
—
ON ON ON ON
—
—
—
MUST BE IN OFF POSITION
5881EN-SOC-V4
Advertisement
