Makita HS012GZ Instruction Manual page 13

Installing and removing circular saw blade
CAUTION:
Be sure the circular saw blade is
installed with teeth pointing up at the front of the
tool.
CAUTION:
Use only the Makita wrench to
install or remove the circular saw blade.
Installing circular saw blade
The circular saw blade may have already been installed
at the time of shipment.
1. Loosen the lever on the depth guide and move the base down.
2. Press the shaft lock fully so that the mounting
shaft cannot revolve and use the hex wrench to loosen
the hex bolt. Then remove the hex bolt and outer flange.
1
Fig.18
► 1 . Shaft lock 2. Hex wrench 3. Loosen 4. Tighten
3. Install the inner flange, ring (country specific), circular saw
blade, outer flange and hex bolt. At this time, align the direction
of the arrow on the circular saw blade with the arrow on the tool.
For tool without the ring
1
2
3
4
5
6
Fig.19
► 1 . Hex bolt 2. Outer flange 3. Circular saw blade
4. Arrow on the circular saw blade 5. Inner flange
6. Arrow on the tool
2
4
3
For tool with the ring
1
2
3
4
5
6
7
Fig.20
► 1 . Hex bolt 2. Outer flange 3. Circular saw blade
4. Arrow on the circular saw blade 5. Ring 6. Inner
flange 7. Arrow on the tool
4. Press the shaft lock and tighten the hex bolt.
For tool with the inner flange for other
than 15.88 mm hole-diameter saw blade
The inner flange has a certain diameter protrusion on one
side of it and a different diameter protrusion on the other side.
Choose a correct side on which protrusion fits into the saw
blade hole perfectly. Mount the inner flange onto the mounting
shaft so that the correct side of protrusion on the inner flange
faces outward and then place saw blade and outer flange.
1 2
Fig.21
► 1 . Mounting shaft 2. Inner flange 3. Circular saw
blade 4. Outer flange 5. Hex bolt
WARNING:
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
WARNING:
the inner flange that is positioned outside fits into the
saw blade hole "a" perfectly. Mounting the blade on the
wrong side can result in the dangerous vibration.
13 ENGLISH
3
BE SURE TO TIGHTEN THE HEX
Make sure that the protrusion "a" on
5
4