Replacing/Cleaning The Spark Arrester Screen - Makita DPC6411 Instruction And Safety Manual

12 14 13
F
17
15
G
H
26
16
18
17
Press the cutting attachment (12) onto the drive arm in the side
position.
Guide the V-belt (13) over the V-belt pulley (14).
Put the guard plate (15) on.
Screw on nuts (16) and tighten by hand.
To tighten the V-belt see "Tightening the V-belt / Checking V-
belt tension".
Tighten the nuts (16) firmly with the combination wrench.
Replace the grip (17) as shown.
IMPORTANT:
When you reposition the cutting attachment, the direction
of rotation of the cutting wheel changes.
If a rotation direction is marked on the cutting disc, make
sure the disc turns in the right direction.

Replacing/cleaning the spark arrester screen

STOP
The spark arrester screen should be checked and cleaned
regularly.
Loosen the 2 screws (18) and remove the spark arrester
screen (19).
Reassembly the spark arrester screen and tighten the screws.
CAUTION:
Do not use sharp or pointed objects for screen cleaning.
Damaged or misformed screen wires may result.