9: Test Switches; 10: Connecting Ac Power; 11: Backup Battery For Evs-100W - Honeywell SILENT KNIGHT EVS Series Manual

Installing the EVS-100W
4.6.9 Test Switches
See Figure 4.34 on page 34 for the location of the Test slide switches.
SW1 - AMP A
Switch should be moved to the "ON" position for normal operation. Move this switch to the "Test" position to test backup amplifier.
SW2 - AMP B
Switch should be moved to the "ON" position for normal operation. Move this switch to the "Test" position to test backup amplifier.
NOTE: Allow up to 3 minutes for backup amplifier to engage.
4.6.10 Connecting AC Power
At installation, connect the AC terminals to the power source as shown in Figure 4.45. It may be necessary for a professional electrician to
make this connection.
The AC terminals are rated as 120VAC, 60 Hz.
4.6.11 Backup Battery for EVS-100W
The following steps explain how to connect the batteries (refer to Figure 4.46):
1. Connect the black wire of the battery harness to the (-) side of the battery #2.
2. Connect the jumper wire provided form the positive (+) side of battery #2 to the negative side of battery #1.
EVS Series Manual — P/N LS10062-001SK-E:D 3/15/2022
Position
(default)
0
1
2
3
Figure 4.44 DIP Switch Modes
Figure 4.45 AC Connection
EVS Device Installation
41