Honeywell Notifier NFS-320/E/C Operation Manual page 4

Fire alarm control panel

Hide thumbs

Table Of Contents

Table of Contents

Installation Precautions

Adherence to the following will aid in problem-free installation with long-term reliability:

WARNING - Several different sources of power can be

connected to the fire alarm control panel. Disconnect all

connected to the fire alarm control panel.

sources of power before servicing.

sources of power before

servicing. Control unit and associ-

ated equipment may be damaged by removing and/or insert-

ing cards, modules, or interconnecting cables while the unit is

energized.

energized. Do not attempt to insta

Do not attempt to install, service, or operate this

unit until manuals are read and understood.

CAUTION - System Re-acceptance Test after Software

CAUTION -

System Re-acceptance Test after Software

Changes:

Changes: T T o ensure proper system operation,

o ensure proper system operation, this product

must be tested in accordance with NFPA 72 after any pro-

must be tested in

accordance with NFPA 72 after any pro-

gramming operation or change in site-specific software.

gramming operation or

change in site-specific software. Re-

acceptance testing is required after any change, addition or

deletion of system components, or after any modification,

repair or adjustment to system hardware or wiring. All compo-

nents, circuits, system operations, or software functions known

to be affected by a change must be

to be affected by

a change must be 100% tested.

to ensure that other operations are not inadvertently affected,

at least 10% of initiating devices that are not directly affected

by the change, up to a maximum of 50 devices, must also be

tested and proper system operation verified.

This system

This system meets NFPA requirements for operation at 0-49º

meets NFPA requirements for operation at 0-49º

C/32-120º F

C/32-120º F and at

and at a relative

a relative humidity

condensing) at 32°C ± 2°C

condensing) at 3

2°C ± 2°C (90°F ± 3°F).

life of the system's standby batteries and the electronic com-

ponents may be adversely affected by extreme temperature

ranges and humidity. . Therefore, it is recommended

ranges and humidity

Therefore, it is recommended that this

system and its peripherals be installed in an environment with

a normal room temperature of 15-27º C/60-80º F.

a normal room temperature of

Verify that wire sizes are adequate

Verify that wire sizes are adequate for all initiating and indi-

cating device loops. Most devices cannot tolerate more than

cating device loops.

Most devices cannot tolerate more than a a

10% I.R. drop from the specified device voltage.

FCC Warning

WARNING: This equipment generates, uses, and can

WARNING:

This equipment generates, uses, and can

radiate radio frequency energy and if not installed and

used in accordance with the instruction manual may

cause interference to radio communications. It has been

tested and found to comply with the limits for class A

computing devices pursuant to Subpart B of Part 15 of

FCC Rules, which is designed to provide reasonable

protection against such interference when devices are

operated in a commercial environment. Operation of this

equipment in a residential area is likely to cause interfer-

ence, in which case the user will be required to correct

the interference at his or her own expense.

Acclimate Plus™, , HARSH™

Acclimate Plus™

HARSH™, , NIS™

NIS™, , Notifier Integrated Systems™

NOTIFIER® , , ONYX®

NOTIFIER®

ONYX® , , UniNet®

UniNet® , , VeriFire®

LonWorks™

LonWorks™ is a trademark of Echelon Corporation.

is a trademark of Echelon Corporation. ARCNET®

registered trademarks of the Microsoft Corporation.

registered trademarks of the Microsoft Corporation. LEXAN®

NFS-320/E/C Operations Manual —

NFS-320/E/C Operations Manual — P/N

Disconnect all

Control unit and associ-

ll, service, or operate this

this product

100% tested. In addition,

In addition,

humidity 93% ± 2

93% ± 2% RH (non-

% RH (non-

(90°F ± 3°F). However,

However, the useful

the useful

that this

15-27º C/60-80º F.

for all initiating and indi-

Notifier Integrated Systems™, , NOTI•FIRE•NET™

VeriFire® , and

, and VIEW®

VIEW® are all registered trademarks of Honeywell International Inc.

are all registered trademarks of Honeywell International Inc. Echelon®

ARCNET® is a registered trademark of Datapoint Corporation.

LEXAN® is a registered trademark of

is a registered trademark of GE Plastics, a subsidiary of General Electric Company.

rights reserved. Unauthorized use of this document is strictly prohibited.

P/N 52747:A

52747:A 12/28/2006

12/28/2006

Like all solid state electronic devices, this system may

Like all solid state electronic devices,

operate erratically or can be damaged when subjected to light-

ning induced transients. Although no system is

ning induced transients.

immune from lightning transients and interference, proper

grounding will reduce susceptibility. Overhead or outside aerial

wiring is not recommended, due to an increased susceptibility

to nearby lightning strikes.

to nearby lightning strikes. Consult with the T

vices Department if any problems are anticipated or encoun-

tered.

Disconnect AC power and batteries prior to removing or

Disconnect AC power and batteries

Re-

inserting circuit boards. Failure to do

inserting circuit boards.

Remove all electronic assemblies

Remove all electronic assemblies prior to any drilling, filing,

reaming, or punching of the enclosure. When possible, make

all cable entries from the sides or rear. . Before making modifi-

all cable entries from the sides or rear

cations, verify that they will not interfere with battery, trans-

former, or printed circuit board location.

Do not tighten screw terminals

Do not tighten screw terminals more than

tightening may damage threads, resulting in reduced terminal

contact pressure and difficulty with screw terminal removal.

This system contains static-sensitive components.

Always ground yourself with a proper wrist strap before han-

dling any circuits so that static charges are removed from the

body.

body. Use static suppressive packagin

Use static suppressive packaging to protect electronic

assemblies removed from the unit.

Follow the instructions in the installation, operating, and pro-

Follow the instructions

gramming manuals. These instructions must be followed to

avoid damage to the control panel and associated equipment.

FACP operation and reliability depend upon proper installation.

Canadian Requirements

This digital apparatus does not exceed the Class A limits

This digital apparatus does not exceed the Class

for radiation noise emissions from digital apparatus set

out in the Radio Interference Regulations of the Cana-

dian Department of Communications.

Le present appareil numerique n'emet pas de bruits

Le present appareil numerique n'emet pas de bruits radi-

oelectriques depassant les limites applicables aux appa-

oelectriques depassant les limites applicables aux

reils numeriques de la classe A prescrites dans le

Reglement sur le brouillage radioelectrique edicte par le

ministere des Communications du Canada.

NOTI•FIRE•NET™, and

, and ONYXWorks™

ONYXWorks™ are all trademarks; and

is a registered trademark of Datapoint Corporation. Microsoft®

GE Plastics, a subsidiary of General Electric Company.

this system may

Although no system is completely

completely

Consult with the Technical Ser-

echnical Ser-

prior to removing or

Failure to do so can damage circuits.

so can damage circuits.

prior to any drilling, filing,

Before making modifi-

more than 9 in-lbs.

9 in-lbs. Over-

g to protect electronic

in the installation, operating, and pro-

Precau-D1-9-2005

A limits

are all trademarks; and FlashScan®

FlashScan® , , NION®

Echelon® is a registered trademark and

is a registered trademark and

Microsoft® and

and Windows®

Windows® are

prohibited.

Over-

radi-

appa-

NION® , ,

are

3 3

Table of Contents

Honeywell Notifier NFS-320/E/C Operation Manual page 4

Related Manuals for Honeywell Notifier NFS-320/E/C

Related Products for Honeywell Notifier NFS-320/E/C

Table of Contents