Table of Contents
Advertisement
SET UP & USE
8. Tighten all the screws and butterfly nuts and move the stand to where you intend
to attach it to the wall.
9. Mark the position on the wall where the holes on H (ANTI-TIP BRACKET) will
connect to the wall to mark the location of O (DRYWALL SCREWS WITH
ANCHOR). Drill a hole in the wall slightly smaller than the diameter of the plastic
wall anchor. Insert the wall anchor securely into the hole so the plastic anchor is
flush with the wall. Using a Philips head screwdriver, insert the screw through the
hole in the H (ANTI-TIP BRACKET) and into the plastic anchor.
10. Place A2 (NON-SLIP PAD) on both A (LEFT DRYER SUPPORT) and A1 (RIGHT
DRYER SUPPORT).
A2
A2
A2
A2
Page 9
Advertisement
Table of Contents
