Table of Contents
Advertisement
SET UP & USE
6. Align the holes in H (ANTI-TIP BRACKET), J (DIAGONAL SUPPORT RAIL) and D
(UPPER LEFT REAR VERTICAL POLE) as shown. The other end of J (DIAGONAL
SUPPORT RAIL) should be attached to E1 (LOWER RIGHT REAR VERTICAL
POLE).
Insert L (Short bolt) through the hole in H (ANTI-TIP BRACKET) first to secure
with N (butterfly nut) on the opposite side.
7. Align the holes in H (ANTI-TIP BRACKET), J (DIAGONAL SUPPORT RAIL)
and D1 (UPPER RIGHT REAR VERTICAL POLE) as shown. The other end of J
(DIAGONAL SUPPORT RAIL) should be attached to E (LOWER LEFT REAR
VERTICAL POLE).
Use N (butterfly nut) and L (Short bolts) to secure.
Page 8
E1
D1
E1
D
D
H
H
J
J
E
Butterfly Nut
Advertisement
Table of Contents
