Sactivate; Sclear; Disassemble [Start [Ninstr]]; Ldisassemble [Start [Ninstr]] - Fujitsu F2MC-16L Series User Manual

3.6.6.

SACTIVATE

Activate Symbols
In the case where the symbol table has not been activated during program download, the
SACTIVATE command can be used to scan the memory for a symbol table and initialise the
symbol management.
>sactivate↵
NOTE: If another symbol table was already active and a new one should be activated, the old
one must be cleared (see SCLEAR) if it starts at a lower address. Otherwise, the old
table will be found again.
3.6.7.

SCLEAR

Erase Symbol Table
The Clear Symbols command will delete the symbol and thus disable the symbolic debug
features.
>sclear↵
3.6.8. DISASSEMBLE [ S
Disassemble Memory
The Disassemble command disassembles the instructions beginning at address Start. If nInstr is
specified this number is disassembled. Sixteen instructions are displayed if nInstr is not given.
Without Start parameter a default address is used.
>disass ff01022↵
>disass _main 30↵
3.6.9. LDISASSEMBLE [ S
Disassemble one Instruction
The Ldisassemble command works similar as the Disassemble command. However, if nInstr is
not specified, only one instruction is displayed.
>l ff01022↵
>l,5↵
... The first example disassembles one instruction at address FF01022h. The second example
displays five instructions.
- 36 -
FUJITSU MB90675-Evaluation Board - User Manual
TART
[ I ]]
N NSTR
[ I ]]
TART N NSTR
© FUJITSU Mikroelektronik GmbH 1996