Makita MW001G Instruction Manual page 12

3. Wash the sponge filter in water and dry well or
blow out the sundries and dust adsorbed in the
sponge filter with an air duster. When the sponge
filter is damaged and cannot be cleaned, replace
the sponge filter in time.
► Fig.7: 1. Filter cover 2. Sponge filter
Storage
When the appliance is not used, place the appliance
indoor and ventilated area.
MAINTENANCE and
INSPECTION
Maintenance
WARNING:
MICROWAVE RADIATION
Remove the battery cartridge before maintenance.
There is microwave radiation and high voltage in the
microwave oven. The high-voltage capacitor still has
dangerous voltage within 30 seconds after the power
is cut off. It is necessary to use a tool with insulating
handle to short-circuit and discharge the capacitor
terminal with the shell. To avoid injury to human
body, it is strictly prohibited to disassemble
and repair by yourself except the maintenance
technicians.
CAUTION:
Always be sure that the appliance
is switched off, unplugged, and the battery car-
tridge is removed before attempting to perform
inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Error code
When the appliance detects a fault, the control panel
displays the corresponding fault code as follows:
Error code
F01 The appliance is placed about over
30 degrees from level angle.
Check whether the appliance is placed
horizontally.
F02 Overcurrent.
Shut down and restart after replacing the
battery.
F03 Overvoltage.
Shut down and restart after replacing the
battery.
F04 Over-temperature.
Let the appliance stand for a period of
time and restart the appliance after it cools
down.
Matter
12 ENGLISH
Error code
F05 Failure of the fan inside the appliance.
Turn off and restart the appliance.
F06 Failure of the magnetron inside the
appliance.
Turn off and restart the appliance.
F07 Failure of internal energization.
Turn off and restart the appliance.
F09 The door opening and closing protection
function may active.
Refer to the section for the door opening
and closing protection function.
If the error still does not improve, turn off
and restart the appliance.
If the error still does not improve, take the appliance to
Makita Authorized or Factory Service Centers.
Servicing
Check the appliance working correctly or not by
following:
Place one cup of water in a heat-resistant glass
(approx.150ml) in the cavity and close the door
securely. Let the appliance work for 1 min.
— Does the light inside the cavity turns on?
— Does the water inside the cavity become hot?
If "NO" is the answer to any of the above questions,
the appliance has some problem inside. Ask Makita
Authorized or Factory Service Centers to repair.
Disposal
WARNING:
Dispose the appliance properly.
Disposal of the appliance should be performed
according to local ordinances and by laws.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita appli-
ance specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Makita genuine battery and Makita authorized
charger
• Shoulder belt
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
Matter