Buffalo CH423 Instruction Manual page 5

Assembly
Before assembly, ensure to:
• Disconnect the appliance from the
power supply.
• Clean all cutting discs and parts that
come into contact with food with warm
soapy water. For details, refer to section
"Cleaning, care & maintenance".
1. Remove the pusher and lift the pusher handle
fully.
2. Lift the locking pad and open the lid backward.
Locking pad
Lid
3. Mount the plastic ejector onto the shaft.
4. Choose the desired cutting disc and mount
onto the shaft, ensuing the flat side is facing
upward.
5. Lift the locking pad and close the lid into place.
6. Place the vegetables in the feeding chute.
Then lower the pusher handle fully.
Cutting Vegetables
1. Connect the appliance to the power supply.
2. Place a container beneath the cutter mouth to
collect the cut vegetables.
3. Press the Start button (I). The disc begins to
spin.
4. Press down on the pusher handle or the food
pusher. As the vegetables are cut, they are
ejected from the cutter mouth.
5. Once all vegetables are cut, press the Stop
button (O) to turn Off. Disconnect the
appliance from the power supply.
CH423_ML_A5_v1_20220615.indb 5 CH423_ML_A5_v1_20220615.indb 5
Selecting a Cutting Disc
Up to 5 cutting discs are available for use with
different tasks.
Disc
Fine grating disc
Note: Onion cannot be cut using
this disc
Medium grating disc
Note: Onion cannot be cut using
this disc
Coarse grating disc
Note: Onion cannot be cut using
this disc
2mm slicing disc: Suitable for
thin slicing
4mm slicing disc: Suitable for
thick slicing
Note: Regularly check the screws fixing the
blades to the cutting discs and tighten as
necessary.
Changing the cutting disc
Warning: The blades on the cutting disc are
sharp. Handle with care!
1. Turn off and disconnect the appliance from the
mains power supply.
2. Open the lid as instructed in section "Assembly".
3. Turn the cutting disc anti-clockwise and
remove. This may require a sharp tap to free it
from the shaft.
4. Slot the new disc in place. Turn if necessary to
drop the disc in place.
Note: Ensure the appliance is clean and free from
food debris when changing disc to ensure the disc
can be securely fitted.
5. Lower the lid and pusher handle consecutively
in place.
EN
Use
5
2022/6/15 11:24 2022/6/15 11:24