S/Rf Meter; External Speaker; Pa (Public Address) - Cobra 29 LX Owner's Manual

Operation
1.5 2 3
CAL
3 5 7 9
1
+30dB
DYNAMIKE RF GAIN DELTA TUNE
MIN MIN MAX
20
29LX_MANL_TH_REV_082222.indd 20-21 29LX_MANL_TH_REV_082222.indd 20-21

S/RF Meter

This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
The S/RF-SWR-CAL button must be in the
S/RF mode.

External Speaker

The external speaker jack is used for remote
receiver monitoring.
Connect an external speaker to the external
speaker jack on the rear panel.
NOTE: The external speaker should have
8-ohm impedance and be rated to handle
at least 4.0 watts. When the external
speaker is plugged in, the internal speaker is
automatically disconnected. See accessory
page X.
NOTE: Cobra external speakers are rated at
10 watts.

PA (Public Address)

1. Connect an external PA speaker to the PA
jack on the rear panel.
2. Press CB/WX/PA button to select PA.
NOTE: The speaker should have 8-ohm
impedance and be rated to handle at least
4.0 watts.
CH 9/
SCAN
19
NOTE: The speaker should be directed away
MEM SCAN
from the microphone to prevent acoustic
ESC
feedback.
SWR
T BACK
CAL
NOTE: Activity on the CB channel will be
heard through the PA speaker. Adjust Volume
Control to a normal listening level.
OFF
Operation
PUSH &
HOLD
3. Push and hold microphone button and
speak in a normal voice. Your voice will
now transmit on the PA speaker.
4. Adjust PA speaker volume with the
Dynamike control.
®
8/26/22 2:37 PM 8/26/22 2:37 PM
21