Table of Contents
Advertisement
Getting Started
PLACING A CALL
Using a Standard Telephone
1. Lift the telephone receiver. Wait for the dial tone.
2. Dial the number of the remote site.
3. When the answer back tone is heard, immediately press the TALK/
DATA button and hang up the telephone. The modems go through a
connection sequence and establish a data link. If a data link is not
established, return to the first step.
4. After the link is established, hang up the telephone.
Autodial from Front Panel
1. If no number to dial is stored yet advance to Main Menu
#6, CHANGE PHONE NUMBER.
2. Enter the number using NO to scroll and YES to select.
3. When number is entered press YES to store the number.
4. Advance the LCD to main #2, DIAL STORED NUMBER.
5. Select number to dial and press YES to dial. After dialing
the modems follow the same procedure as when using a
standard telephone.
Autodial from a Terminal with the AT Command Set
To dial a number, for example 555-1212, type AT D 555-1212 and press
Enter, or enter ATDSn where n equals the stored telephone number loca-
tion 1-9 to dial.
The modem dials the number — either pulse or tone, whichever is
currently in effect — and takes the role of the originate modem.
Refer to Dial Commands section in Chapter 5 for additional dialing
commands.
3-2
V.3400
Advertisement
Table of Contents
