Sony BETACAM SX DNV-5 Maintenance Manual page 33

1-10. Ejecting the Cassette Tape
Manually
n
Be sure to turn off the power, then pull out the power cord
and/or battery before performing the following procedure.
If not, damage to internal circuit may result.
1. Open the cover of the outside panel shown in the
figure.
2. Turn the gear clockwise while pushing a gear down-
ward until the front lid opens using a Philips screw-
driver.
Then confirm that the tape is taken up the cassette
reel.
3. The front lid opens. The cassette tape can then be
ejected.
Front lid
m
. Never turn the gear no further after the front lid opened.
. Closing the front lid
In the state mentioned above, the front lid cannot be
closed and locked. Turn on the power, then close the
front lid.
DNV-5
If the above operation cannot be executed,
perform the following procedure.
1. Remove the front lid and outside panel.
2. Put the cassette compartment into the cassette-up state
3. Remove the cassette tape taking care that the tape does
2
Cover
1
Turn while pushing
(clockwise)
1-10. Ejecting the Cassette Tape Manually
(Refer to section 1-6.)
with the cassette lid of the cassette tape raised.
(For more details, refer to section 1-7.)
not get damage.
1-27