Bosch AUTODOME IP starlight 5000i IR User Manual page 27

AUTODOME IP starlight 5000i IR
–
–
–
Inactivity period
Determines the behavior of the camera when the control for the camera is inactive. Select a
time period from the pull-down list (3 s - 24 h). The default setting is 30 seconds.
Auto pivot
The Auto pivot tilts the camera through the vertical position as the camera is rotated to
maintain the correct orientation of the image. Set the Auto Pivot to On (default) to
automatically rotate the camera 180º when following a subject traveling directly beneath the
camera. To disable this feature, click Off.
Freeze frame
Select On to freeze the image while the camera moves to a predetermined scene position.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The camera can make up to two (2) recorded tours. A recorded tour saves all manual camera
movements made during the recording, including its rate of pan, tilt and zoom speeds, and
other lens setting changes. The tour does not capture camera video during the recording of
the tour.
Note 1: You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
2.
3.
4.
5.
Note: Tour B is now intended for use with the 'IVA while moving' functions.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
North point
–
–
Alternative home position
Click Set to set the alternative home position for the camera.
Click Clear to clear the alternative home position.
Bosch Security Systems
Off (default): camera remains on a current scene indefinitely.
Pre-position 1: camera returns to Pre-position 1.
Previous AUX: camera returns to the previous AUX activity.
Click the Start Recording button. The system prompts you to overwrite the existing tour.
Click Yes to overwrite the existing tour movements.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
Use the View Control dialog box to make the necessary camera movements.
Click the Stop Recording button to save all actions.
Determine the North compass heading, then move the camera to that position.
Select the radio button On for the parameter Compass.
Click the button next to North point to set the calibration point.
Click the Set button to overwrite the existing North point. A dialog box appears with the
message, "Overwrite North point?" To confirm, click OK. To cancel, click Cancel.
Click the Clear button to reset the North point to factory defaults. A dialog box appears
with the message, "Reset North point to factory defaults?" To confirm, click OK. To
cancel, click Cancel.
User Manual
Camera | en 27
2023-01 | 1.3 |