Chapter 4 Adjustments And Updating Of Settings, Required After Parts Replacement; If You Replace The Main Pcb - Brother HL-3160CDW Service Manual

CHAPTER 4 ADJUSTMENTS AND
1.

IF YOU REPLACE THE MAIN PCB

■
What to do after replacement
• Configure for Country/Region and Model (Function code 74)
• Installing the Firmware (Sub Firmware and Main Firmware)
• Initializing the EEPROM of the Main PCB (Function code 01)
• Adjusting Touch Panel (Function code 61) (Touch panel models only)
• Continuous Adjustments of Density and Registration Sensor (Function code 73)
• Setting the Serial Number (Function code 80)
■
What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Service setting tool (SvSettingTool)
(Only when setting the Serial Number using computer.)
Copy it into the temporary folder that has been created in the C drive.
(4) Download utility (Filedg32.exe)
Copy it into the temporary folder that has been created in the C drive.
(5) Maintenance printer driver (Maintenance_driver.zip)
When the maintenance printer driver is not installed, copy this file into the temporary
folder created on the C drive, and extract the copied file. Refer to
INSTALLING THE MAINTENANCE PRINTER DRIVER"
(6) Firmware
Sub firmware
Main firmware
(7) Touch pen
(8) Memory access tool (MemoryAccessTool.exe) (only for using SvSettingTool.)
UPDATING OF SETTINGS,
REQUIRED AFTER PARTS
REPLACEMENT
djf file (ex. ******_A.djf)
djf file (ex. ******_A.djf)
4-1
®
XP or later).
"APPENDIX 3
to install the driver.
Confidential