T1 Pick-Up Clutch / Registration Clutch / Paper Feed Drive Unit - Brother HL-3160CDW Service Manual

9.19 T1 pick-up clutch / Registration clutch /
Paper feed drive unit
(1) Release the T1 pick-up clutch harness from the securing fixtures. Release the Hook to
remove the T1 pick-up clutch.
(2) Release the Hook of the T1 bearing 6, and then rotate it in the direction of the arrow to
pull out the Sep roller drive joint. Remove the T1 bearing 6 from the Sep roller drive joint.
(3) Release the Registration clutch harness from the securing fixtures. Release the Hook to
remove the Registration clutch.
(4) Release the Hook of the Regi joint bearing, and then rotate it in the direction of the arrow to
pull out the PF regi drive joint. Remove the Regi joint bearing from the PF regi drive joint.
(5) Release the Hook to remove the PF bearing 5. Pull out the Feed roller drive shaft.
<Left side>
T1 bearing 6
Harness routing: Refer to
Assembling Note:
• When wiring the T1 pick-up clutch harness and the Registration clutch harness, make sure
that the clutch connection part of each harness does not stretch by pulling too much.
Hook
Feed roller drive shaft
Sep roller drive joint
T1 bearing 6
T1 pick-up clutch
Hook
Fig. 3-60
"2. Main PCB, Cartridge sensor relay
3-69
Regi joint bearing
PF regi drive joint
Registration clutch
Regi joint bearing
PF bearing 5
Hook
Hook
Registration clutch harness
T1 pick-up clutch harness
PCB".
Hook
Confidential