AEG A9WHMIC1 User Manual page 68

68
2. The position of your filter needs to
follow these listed points (a and b):
a. Position the wall support at the correct
height, measuring 110 cm* from top of the
wall support to the floor (or pedestal if
present). *Tolerance admitted in filter
height position is +/-5 cm.
110 cm
b. Use a level to check that the 3 drilling
punches are level and well-aligned before
drilling.
110 cm
Check where your point of
drainage is before positioning
the wall support. Filter is
equipped with one drainage
pipe with length of 100 cm.
Make sure there is enough
space above your filter before
positioning the wall support.
Be sure to leave adequate free
space above the filter in order
to remove and re-insert the
cartridge. See minimum
dimensions reference in
Appendix 1 (Front Loader) and
Appendix 2 (Top Loader).