NETGEAR WPNT121 User Manual page 28

NETGEAR RangeMax™ 240 Wireless USB 2.0 Adapter WPNT121 User Manual
3. Save your settings in a Profile.
a. Click Save Profile.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
5. Verify wireless connectivity between your peer devices.
You can use the ping utility to verify your wireless connection:
a. On the Windows taskbar click Start, and
then click Run.
b. Assuming the target PC is configured
with 192.168.0.1 as its IP address, type
ping -t 192.168.0.1
OK.
c. This sends a continuous ping to the device with the 192.168.0.1 static IP address. The ping
response should change to "reply."
Figure 3-5
3-6
and then click
Figure 3-4
v1.0, February 2006