Wg311T Default Wireless Configuration Settings - NETGEAR WG311 Installation Manual

Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T

WG311T Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your NETGEAR 108 Mbps Wireless PCI Adapter WG311T factory default basic settings are:
• Network Name Service Set Identification (SSID):
first available network will be used
: In order for the WG311T Wireless PCI Adapter to communicate with a wireless access
Note
point or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-Hoc):
• Data security WEP encryption: Disabled
The section below provides instructions for setting up the NETGEAR 108 Mbps Wireless PCI
Adapter WG311T for basic wireless connectivity to an access point. The procedures provide
step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the
version of Windows you are using.
Basic Setup
ANY — a special name which indicates the
Infrastructure
2-3