Main Screen> Switch Setting> Configuration Setting; Main Screen> Switch Setting> Password Change; Figure 4-3. Main Screen: Switch Setting> Configuration Setting; Figure 4-4. Main Screen: Switch Setting> Password Change - NETGEAR FS526T User Manual

Main Screen> Switch Setting> Configuration Setting
Select a switch by clicking on it. Then click Configuration Setting. The following screen pops up, enabling you modify:
System Name
o
Location
o
Password
o
DHCP
o
System Name
o
Location
o
Password
o
DHCP
o
Main Screen> Device Setting> Configuration Setting> Set
Click 'Set' to enable new settings. You must enter your password for these settings to be accepted.
Main Screen> Device Setting> Configuration Setting> Cancel
Click 'Cancel' to abort the above settings.
Main Screen> Switch Setting> Password Change
Click 'Password Change' from the Switch Setting section. The following screen pops up as shown in Figure 4-4.
New Password
o
Confirm Password Re-type the new password to confirm it.
o
Old Password
o
Click 'Set' to enable new password.
This field is to help you keep track of your switches. It can be any combination of letters and/or numbers.
This field is to help you keep track of where this switch is. It can be any combination of letters and/or numbers.
The default password is 'password'. You must enter your password for and modifications to take affect.
DHCP automatically obtains the IP information for the switch.
Figure 4-3. Main Screen: Switch Setting> Configuration Setting
Any desired description for System Name.
Any desired description for Location.
The default password is 'password'.
This function is enabled by default. Click 'Disable' to abort the function.
Figure 4-4. Main Screen: Switch Setting> Password Change
Type any desired password. Passwords are case-sensitive and can have a maximum of 20 characters.
The default password is 'password'.
Page 19 of 58