Advertisement
Control Testing Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect power and gas to range before servicing,
unless testing requires power and/or gas.
Controller
Oven temperature
M1
adjustment
Temperature display
M1
Clock display
M1
24-hour Clock
M1
Factory default
M1
12-hour off
M1
Sabbath mode
M1
Child lock out
M1
Diagnostic code
M1
display
16027222
Replaces 16022499
!
WARNING
Feature
Press BAKE pad.
Enter 550 on the digit-pad.
Immediately press and hold BAKE
pad for 3 to 5 seconds.
Oven can be adjusted from -35 to +35
degrees in 5-degree increments by
pressing AUTOSET pad. To avoid
over adjusting the oven, move
temperature 5 degrees each time.
Wait 4 seconds for the data entry timer
to expire to accept the change.
Temperature adjustment will be
retained even through a power failure.
Press and hold Cancel and Bake
pads for 3 to 5 seconds.
Press and hold Cancel and Clock
pads for 3 to 5 seconds.
Press and hold Cancel and Delay
pads for 3 to 5 seconds.
Press and hold Cancel and Keep
Warm pads for 3 to 5 seconds.
Control will automatically cancel any
cooking operation and remove all
relay drives 12 hours after the last pad
touch.
Hold CLOCK pad for 3 to 5 seconds to
activate Sabbath mode.
Hold CLOCK pad for 3 to 5 seconds to
disable Sabbath mode.
Press and hold Cancel and Cook &
Hold pads for 3 to 5 seconds. "OFF"
will display where the temperature
normally appears. "LOCK" will display
flashing while door is locking.
To reactivate the control, press and
hold Cancel and Cook & Hold pads
for 3 to 5 seconds.
Press and hold Up Arrow pad and
Power Up the unit.
Cycle through the codes using the
number pads 1 through 5.
Procedure
While increasing or decreasing oven
temperature, this does not affect self-
cleaning temperature.
Toggles temperature display between °F
and °C.
Toggles clock display on and off.
Toggles time display between 12 or 24
hour format.
Allows the clock to be reset to factory
settings.
See Sabbath mode to disable.
"SAb" flashes for 5 seconds.
Display returns to time of day.
All pad inputs are disabled except for
CANCEL and CLOCK pads.
This mode disables the normal 12 hour
shutoff to allow operation of the bake
mode for a maximum of 72 hours.
Safety feature that used to prevent
children from accidentally programming
the oven. It disables the electronic oven
control.
Child lockout features must be reset after
a power failure.
The last 5 diagnostic codes will be stored
in the non-volatile memory.
See "Description of Error Codes" for
explanation.
4
Results
May 2006
© 2006 Maytag Services
Advertisement
