Figure 3-22 Add Event
Perform the following steps to add an event as shown in the above figure:
1. Select an event type among
•
Camera event
•
System event
•
External device event
2. Click Add trigger to select trigger and source. After it is completed, click Add.
3. Click Add action to select a corresponding action, such as sending HTTPS request,
sending live streaming, sending an Email, going to camera preset, going to E-Map or
sounding the event. For details, see
Add.
4. Configure a schedule during which the event configuration will take effect.
•
If no special time is needed, you can simply select Always.
•
To configure a schedule, click Customize. For details, see
5. Enter a name for your event, and add description for your configuration, e.g., "motion
detected on the front door." Click Add and the event configuration will be listed as shown
in the following figure.
, see
Camera Event
on page 20.
, see
System Event
on page 21.
, see
External Device Event
Adding Action
on page 22.
on page 23. After it is completed, click
Add a
Schedule on page 26.
Settings
19