Makita GCU05 Instruction Manual page 11

3. Turn the lever counterclockwise until the sprocket
cover comes off.
1
Fig.10
► 1. Lever 2. Sprocket cover
4.
Remove the sprocket cover.
5.
Check the direction of the saw chain. Match the
direction of the saw chain with that of the mark on the
chain saw body.
1
Fig.11
► 1. Mark on chain saw body
6. Fit one end of the saw chain on the top of the
guide bar.
7.
Fit the other end of the saw chain around the
sprocket, then attach the guide bar to the chain saw
body.
1
Fig.12
► 1. Sprocket
8. Turn the adjusting dial to "-" direction to slide the
adjusting pin in the direction of arrow.
2
Fig.13
► 1. Adjusting dial 2. Adjusting pin
9.
Place the sprocket cover on the chain saw so that
the adjusting pin is positioned in a small hole on the
guide bar.
Fig.14
► 1. Sprocket cover 2. Guide bar 3. Hole
10. Turn the lever clockwise fully and turn back the
lever a little to keep looseness for adjusting the chain
tension.
11.
Adjust the chain tension. Refer to the section for
adjusting saw chain tension for procedure.
11 ENGLISH
1
2
3
1
2