Care And Cleaning - Maytag Jetclean MDB4601AWE Use And Care Manual

Care and Cleaning

WARNING
Electrical Grounding Instructions - Portable models are
equipped with a (three-prong) grounding plug for your
protection against shock hazard and should be plugged
directly into a properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
Connecting a Portable
Dishwasher
1. Turn on the faucet at the sink until the water runs
hot. Turn off the faucet.
2. Pull the connector from the recess in the back of
the dishwasher.
3. Press down on the thumb release and lift the
connector onto the faucet.
4. Remove pressure from the thumb release and tug
slightly on the connector to be sure it is securely in
place.
5. Turn the hot water on full force.
6. Check that the sink drain is open so water from the
dishwasher can drain properly.
7. Pull the electrical cord from the recess. Plug it into a
properly grounded outlet.
8. Select the proper cycle and options for the load and
start the dishwasher.
Storage/Moving
Fill both detergent cups with a fresh-scented
dishwasher detergent or baking soda and select the
Heavy Wash cycle. Allow the dishwasher to complete
the cycle. Then turn the water supply off and drain the
dishwasher. To drain, press the Drain/Off pad once to
activate the drain. Operate the drain twice to ensure
most of the water is removed. Last, disconnect the
electrical supply and prop open the door.
When turning the water supply to the home off, the
water shut off at the dishwasher must be turned off
also.
Disconnecting A Portable
Dishwasher
1. Be sure to turn the water supply off and press the
pressure release button BEFORE removing the
connector.
2. Press down on the thumb release and remove the
connector from the faucet.
3. Push the connector and hoses back into the cabinet
recess.
4. Unplug the electrical cord and push it back into the
cabinet recess.
To Change the Door Panel
Insert
(select models)
WARNING – Disconnect electrical power to the
dishwasher before changing the door panel insert.
1. Using a Phillips screwdriver, remove either the right
or left-hand door trim strips by removing the three
screws.
2. Grasp the panel insert(s) and gently flex out slightly.
Slide panel(s) out about two inches. Continue to flex
insert panel(s) enough to remove them. Use care,
edges may be sharp.
3. Select color and reinstall panel(s). Place insert
panel(s) (notched corners at the top) on the inside
of the lower door panel trim. Make sure the upper
notched corners of the insert(s) are under the
control panel.
4. Reinstall the side trim.
8
WARNING