Operation - Makita 5377MG Instruction Manual

To use the hook, simply lift up hook until it snaps into the
open position.
When not in use, always lower hook until it snaps into
the closed position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Hex wrench storage
2
007405
Hex wrench is stored on the tool. To remove hex wrench,
rotate it toward yourself and pull it out.
To install hex wrench, place it on the grip and turn it until
it comes into contact with the protrusion on the grip.
Removing or installing saw blade
1
007398
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the hex wrench to loosen
the hex bolt clockwise. Then remove the hex bolt, outer
flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
COUNTERCLOCKWISE SECURELY.
1. Grip
1
2. Hex wrench
1. Shaft lock
2. Hex wrench
2
5
4
007399
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
CAUTION:
One side of the inner flange is for 5/8" hole
•
diameter of the blade and the other side is for
13/16" hole diameter. Use the correct side for the
hole diameter of the blade you intend to use.
Mounting the blade on the wrong side can result in
dangerous vibration.
2
1
6
007400

OPERATION

CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
2
007401
Hold the tool firmly. The tool is provided with both a front
grip and rear handle. Use both to best grasp the tool. If
both hands are holding saw, they cannot be cut by the
8
1. Saw blade
2. Outer flange
3. Hex bolt
4. Inner flange
1
5. Ring 17
2
3
1. Ring 17
3 2. Inner flange
4
3. Blade
5
4. Outer flange
5. Hex bolt
6. Mounting shaft
1. Rear handle
1
2. Front grip
3. Base
3