Cisco 3200 Series Hardware Upgrade Manual page 45

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
Step 9
Step 10
Step 11
Caution
OL-15983-01
Get user manuals: See SafeManuals.com
Figure 3-8 Attaching Alignment Tabs
1
2
4
3
1
Serial console cable
3 Right alignment tab
Slowly slide the card stack back until the alignment tabs are flush against the extrusion.
Using a small Phillips screw driver, reattach the alignment tabs to the extrusion. Use a torque range of
2.5 to 3.5 in-lb.
Tighten the Wedge Loks on the I/O end cap side with a 3/32-inch hex blade.
sequence for tightening the Wedge Loks. Use a torque range of 5.5 to 5.7 in-lb when tightening the
Wedge Loks.
Make sure that all the Wedge Loks are secure. Thermal transfer will not occur if any Wedge Lok is loose.
2
LED cable
4 Right alignment tab
Figure 3-9
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
shows the
3-9