Disconnecting All Cables From The Enclosure; Removing The Antenna End Cap - Cisco 3200 Series Hardware Upgrade Manual

Card Replacement Process

Disconnecting All Cables from the Enclosure

Warning

Removing the Antenna End Cap

Warning
Caution
Step 1
Step 2
Cisco 3200 Series Router Hardware Upgrade Guide
3-2
Get user manuals: See SafeManuals.com
Before you start working on rugged enclosures, disconnect all cables, including power, to avoid
damage to the unit.
Class 1 laser product. Statement 1008
To remove the antenna end cap of a Cisco 3270 Rugged Enclosure, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Using a 3/8-inch socket wrench and applying 58 to 68 in-lb of torque, loosen the four 1/4-20 bolts on
the end cap.
Carefully pull off the end cap enough to label and then disconnect the antenna cables, if the cables are
present. Figure 3-1 shows the antenna cables.
Figure 3-1 Antenna End Cap Removal
1 WMIC 1 primary antenna cable
3 WMIC 2 primary antenna cable
5
WMIC 3 primary antenna cable
7 RP-TNC antenna connector
Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
1 3 5
2 4 6
2 WMIC 1 secondary antenna cable
4 WMIC 2 secondary antenna cable
6
WMIC 3 secondary antenna cable
7
OL-15983-01