Clamp Bracket And Swivel Bracket; Checking The Clamp Bracket Anode; Installing The Clamp Bracket; Adjusting The Trim Sensor Cam - Yamaha F30B 2018 Service Manual

Checking the clamp bracket anode

1. Check:
• Anode
Eroded (1/2 or more)  Replace.
There is grease, oil, or scales.  Clean.
Do not apply grease, oil, or paint to the an-
ode.

Installing the clamp bracket

1. Install:
• Anode
• Tilt support shaft bushing
• Tilt support shaft
• Tilt support knob
• Pin
• Trim sensor (PTT model)
• Swivel bracket bushing
• Clamp bracket (PORT)
• Through tube
• Swivel bracket
• Trim sensor cam (PTT model)
• Clamp bracket (STBD)
• Self-locking nut
• Stopper
• Ground lead
• Clamp (PTT model)
• Grease nipple
• Holder (PTT model)
Self-locking nut
22 N·m (2.2 kgf·m, 16 lb·ft)
Grease nipple
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
TIP:
Secure the trim sensor lead "1" using the
clamp "2" and holder "3".
3 1 2
2
2. Inject:
• Grease
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Inject grease into the grease nipples until
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲

Adjusting the trim sensor cam

1. Adjust:
• Trim sensor setting resistance
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Fully tilt the swivel bracket down.
b. Loosen the trim sensor cam screw "1".
c. Measure the trim sensor setting resis-
TIP:
• To decrease the resistance, turn the trim sen-
sor cam in direction "a".
• To increase the resistance, turn the trim sen-
sor cam in direction "b".
1
9-31

Clamp bracket and swivel bracket

grease comes out from the bushings "a".
tance. Adjust if out of specification.
a
b
1
Digital circuit tester
90890-03243
Digital multimeter
YU-34899-A
a
d
c