Clamp Bracket And Swivel Bracket; Removing The Ptt Unit; Removing The Clamp Bracket - Yamaha 250GETO Service Manual

Removing the PTT unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
w
9 After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could
suddenly lower if the PTT unit should
lose fluid pressure.
9 When removing the PTT unit without
removing the power unit, be sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could suddenly fall and
result in injury.
NOTE:
If the PTT does not operate, turn the manual
valve counterclockwise and tilt the outboard
motor up manually.
2. Remove the anode 2 and PTT mount
bolts 3.
3. Loosen the self-locking nut 4, and then
move the clamp brackets slightly in the
direction of the arrows.
w
Do not remove the tilt stop lever 1 from
the clamp brackets.
4. Remove the lock ties 5, and then pull
out the PTT motor lead 6.
6S35H11
5. Remove the circlip 7, and then remove
6. Remove the PTT unit 9.
1
S60V3310
2

Removing the clamp bracket

1. Remove the self-locking nut 1 and
2. Remove the trim sensor 5.

Clamp bracket and swivel bracket

the shaft 8.
7
8
6
3
9
ground lead 2, then remove the clamp
brackets 3 and 4.
1
1
4
2
5
3
4
6S370028
5
6
7
8
9
7-18