RIDGID 760 FXP Power Drive Manual page 11

OPEN
Figure 6A – Retaining Mechanism (760 FXP 12-R)
OPEN
Figure 6B – Retaining Mechanism (760 FXP 11-R)
OPEN
Figure 7 – Installing Adapter
6. Installing 11-R Die Heads, 1¼" and smaller (760 FXP
11-R only):
a. Make sure ON/OFF switch is released and battery
removed from tool.
999-995-242.10_REV A
CLOSED
OPENED
CLOSED
Figure 8 – Installing 1
OPENED
7 . Position the power drive Forward/Reverse Slide
760 FXP Power Drive
b. If needed install the adapter, refer to step 5.
c. Squarely insert the octagonal end of the die head
into the power drive until secured by the spring
ring. The die heads can only be inserted from the
adapter side of the tool.
d. To remove, pull die head from power drive. If
needed, use a soft face hammer or a block of
wood to tap the die head out. Do not pound on the
die head, this can damage the tool.
Spring
Ring
/ " or Smaller 11-R Die Heads
1
4
(760 FXP 11-R only)
Switch for the desired right or left hand thread. See
Figure 9.
a. Move the Slide Switch to the Forward rotation po-
sition. This will produce right-hand threads when
the die is inserted from the left (front) side of the
tool.
b. Move the Slide Switch to Reverse position. This
will produce right-hand threads when the die is
inserted from the right (back) side of the tool (for
760 FXP 12-R only).
c. For left-hand threads, reverse the Forward/Re-
verse Slide Switch positions.
9 9