Care And Cleaning - GE AHTT08 Owner's Manual & Installation Instructions

Using the Air Conditioner
Air Direction
Sound ON/OFF
The Sound ON/OFF Mode will be able to turn On and Off
the beep function by the user. Beep will be active when
Sound ON. Beep will be unfunctional when Sound OFF.
Sound On/OFF
Pressing and holding Filter button for 3-5 seconds to
switch Sound function. Beep will be unfunctional when

Care and Cleaning

Grille and Case
Turn the air conditioner off and remove the plug from the
wall outlet before cleaning.
Filters
All filters should be checked and cleaned at least every
250 hours or more often if necessary. Clean the filters
with warm, soapy water. Rinse and let filters dry before
replacing it. Do not clean the filters in a dishwasher.
Front Filter:
Access the Front Filter by first opening the inlet grille.
Pull the tabs on the top sides of the grille towards
you and set it aside. From here, pull down on the top
black tabs on the filter. Once the top of the filter has
been popped out of place, lift upwards on the filter and
remove it from the device.
Side Filter:
Locate the tab on the left side of the unit and pull the
filter straight out.
Plug Filter:
NOTE: Water will not come out after removing the
cap, however it will begin to drain as soon as the Plug
Filter is removed. Ensure to have the proper means of
collecting water under the unit before removing the plug.
Locate the drain cap on the right side of the unit.
Remove the cap, and pull the plug straight out.
49-5000634 Rev. 3
Sound OFF. When Beep ON, it will beep one time. When
Beep OFF active, it will beep three times.
Default Setting
The Default setting for this function was Sound ON.
access to prior setting when power outage recovered.
To clean, use water and a mild detergent. Do not use
bleach or abrasives.
CAUTION
DO NOT operate the air conditioner
without a filter because dirt and lint will clog it and reduce
performance.
Side Filter
Inlet Grille (Front Filter
is behind Inlet Grille)
Drain Cap (Plug Filter is
behind Drain Cap)
7