GE AHTT08 Owner's Manual & Installation Instructions page 12

Installation Instructions
3. WALL REQUIREMENTS
• Measure your window depth and use the table
below to determine the necessary chase-way
position.
Window Depth
Less than 7.75"
7.75" - 9.75"
9.75" - 11.75"
11.75" - 13.75"
* The unit comes in the closed position. If no
adjustment is necessary, skip to Section 5.
Outside
Sill
12
Chase-Way Position
Closed*
1
2
3
Chase-Way
Depth
Stool
Depth
Inside
4. PREPARE THE AIR
CONDITIONER
Adjusting the Chase-Way
• Measure window depth from interior to exterior.
corresponding chase-way position.
• Remove 4 locking screws that hold the chase-way in
place.
• Pull chase-way to position needed based on your
window depth.
PULL
Place tab into slot
to hold desired
position.
Locator Slot
• Place tab of side panel bracket into slot on
chase-way to hold position.
• Install the 4 screws (2 on each side) back into place
to lock in chase-way.
PULL
Locking
Screws (4)
Side Panel
Bracket
Locking
Screws (4)
49-5000634 Rev. 3