Cisco TelePresence SX80 Installation Manual page 3

Installation guide for Cisco TelePresence SX80
Connect to LAN, microphones, loudspeakers, Touch 10, cameras and screens
Make sure all units are switched off when connecting or disconnecting cables.
LAN (RJ-45)
1
Always use the
1 st Ethernet port
for LAN.
4 × programmable
GPIO pins
(Euroblock,
2 × USB
SWITCH
PoE
injector
AP
Touch 10 control panel (RJ-45)
4
Insert the provided PoE injector
between Touch 10 and the codec's
2 or 3 Ethernet port .
nd rd 2
About the 2 and 3 Ethernet port
nd rd
The codec's 2 nd and 3 rd Ethernet ports should be used for the Touch 10 control panel,
as well as for the Cisco's SpeakerTrack 60, Precision 60, and Quad cameras.
Connect a network switch to the codec's 2
two ports to support your devices.
78-100153-03A0rev1 | SEPTEMBER 2019 | © 2019 Cisco Systems, Inc. All rights reserved.
Microphones, max 8 (Euroblock, 3.5 mm)
2
If your microphone cable has 3 pins,
use ,
mute pin ( ) unused.
3.5 mm)
10 Gb Ethernet
Power
(100-240 VAC, To camera control
50/60 Hz)
Cameras (HDMI)
5
How to connect cameras are described
overleaf. Note that different cameras use
different ports for camera control.
or 3 Ethernet port, if you need more than
nd rd
and ground ( ) and leave the
2 × stereo audio line in,
e.g. from PC
(Euroblock, 3.5 mm)
Video input, Analog video input:
e.g. from PC Composite, Y;
(DVI-I) S-video, Y and C
(BNC)
The audio line outputs may be configured to be used for loudspeakers.
1
The Ethernet connector is at the rear of Touch 10. The Ethernet cable between Touch 10 and the PoE
2
injector must be PoE rated (provided). The Ethernet cable between the PoE injector and the codec is not
required to be PoE rated (not provided).
There is no DC power output from the camera control port. Use an external power supply for the camera.
3
Loudspeakers, mono or stereo (Euroblock, 3.5 mm)
3
Use speakers with amplifiers. The speaker/amplifier
should have balanced input to avoid ground loop noise.
2 × stereo audio line out,
e.g. to recorder
1
(Euroblock, 3.5 mm)
Camera control for the
Precision 40 / PrecisionHD
1080p 4xS2 camera
6
Screens, max 3
(2 HDMI, 1 DVI-I)
Serial port Ground
(D-SUB 9) (Protective earth)
Power
(D-SUB 9) 3
3