HIKVISION DS-K3G501LX Series User Manual
HIKVISION DS-K3G501LX Series User Manual

HIKVISION DS-K3G501LX Series User Manual

Tripod turnstile

Advertisement

Quick Links

DS-K3G501LX Series Tripod Turnstile
User Manual

Advertisement

Table of Contents
loading

Summary of Contents for HIKVISION DS-K3G501LX Series

  • Page 1 DS-K3G501LX Series Tripod Turnstile User Manual...
  • Page 2 WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR OWN RISK. IN NO EVENT WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL, CONSEQUENTIAL, INCIDENTAL, OR INDIRECT DAMAGES,...
  • Page 3 During the use of device, personal data will be collected, stored and processed. To protect data, the development of Hikvision devices incorporates privacy by design principles. For example, for device with facial recognition features, biometrics data is stored in your device with encryption method;...
  • Page 4 DS-K3G501LX Series Tripod Turnstile User Manual Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
  • Page 5 DS-K3G501LX Series Tripod Turnstile User Manual This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
  • Page 6 DS-K3G501LX Series Tripod Turnstile User Manual Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into Dangers and Cautions: Dangers: Neglecting any of the warnings may cause serious injury or death.
  • Page 7 DS-K3G501LX Series Tripod Turnstile User Manual Do not ingest battery, Chemical Burn Hazard. ● This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
  • Page 8 DS-K3G501LX Series Tripod Turnstile User Manual Do not drop the device or subject it to physical shock, and do not expose it to high ● electromagnetism radiation. Avoid the equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
  • Page 9 DS-K3G501LX Series Tripod Turnstile User Manual Available Models Product Name Model Tripod Turnstile DS-K3G501LX viii...
  • Page 10: Table Of Contents

    DS-K3G501LX Series Tripod Turnstile User Manual Contents Chapter 1 Overview ........................1 1.1 Introduction ........................... 1 1.2 Main Features ........................1 Chapter 2 System Wiring ......................3 Chapter 3 Installation ......................... 5 3.1 Disassemble Pedestals ......................5 3.2 Install Pedestals ........................5 Chapter 4 General Wiring ......................
  • Page 11: Chapter 1 Overview

    DS-K3G501LX Series Tripod Turnstile User Manual Chapter 1 Overview 1.1 Introduction The tripod turnstile is designed to detect unauthorized entrance or exit. By adopting the turnstile integratedly with the access control system, person should authenticate to pass through the lane via swiping IC or ID card, scanning QR code, etc.
  • Page 12 DS-K3G501LX Series Tripod Turnstile User Manual Online/offline operation ● LED indicates the entrance/exit and passing status ● Barrier is in free status when powered down. People can pass through the lane along single/both ● singe and double directions Fire alarm passing ●...
  • Page 13: Chapter 2 System Wiring

    DS-K3G501LX Series Tripod Turnstile User Manual Chapter 2 System Wiring The preparation before installation and general wiring. Steps 1. Draw a central line on the installation surface of the left or right pedestal. 2. Draw other parallel lines for installing the other pedestals.
  • Page 14 DS-K3G501LX Series Tripod Turnstile User Manual Note The suggested inner diameter of the low voltage conduit is larger than 30 mm. ● If the face recognition module are required to be connected on the left lane, you should ● increase the conduit diameter or bury another conduit for the external cables.
  • Page 15: Chapter 3 Installation

    DS-K3G501LX Series Tripod Turnstile User Manual Chapter 3 Installation 3.1 Disassemble Pedestals Before installation, you should use the key to open the pedestals. View the pictures below to find the lock holes. Figure 3-1 Lock Holes 3.2 Install Pedestals Before You Start Prepare for the installation tools, check the device and the accessories, and clear the installation base.
  • Page 16 DS-K3G501LX Series Tripod Turnstile User Manual Steps Note The device should be installed on the concrete surface or other non-flammable surfaces. ● No face recognition terminal installed: If the installation area is too close to the wall, make sure ●...
  • Page 17 DS-K3G501LX Series Tripod Turnstile User Manual The dimension is as follows. ●...
  • Page 18 DS-K3G501LX Series Tripod Turnstile User Manual Figure 3-2 Dimension 1. Prepare for the installation tools, check the components, and prepare for the installation base. 2. Drill holes on the ground according to the installation holes on the pedestals and insert the expansion sleeves.
  • Page 19: Chapter 4 General Wiring

    DS-K3G501LX Series Tripod Turnstile User Manual Chapter 4 General Wiring 4.1 Components Introduction By default, basic components of the turnstile are connected well. The turnstile supports wiring the AC electric supply for the whole system's power supply. Note The voltage fluctuation of the electric supply is between 100 VAC and 240 VAC, 50 to 60 Hz.
  • Page 20 DS-K3G501LX Series Tripod Turnstile User Manual For product with switching power adapter, the wiring diagram is as follows:...
  • Page 21: Terminal Description

    DS-K3G501LX Series Tripod Turnstile User Manual Warning Terminal PE should connect to a ground wire to avoid hazard when people touching the device. Note The cable bare part should be no more than 8 mm. If possible, wear an insulation cap at the end ●...
  • Page 22: Optional Board Terminal Description (Optional)

    DS-K3G501LX Series Tripod Turnstile User Manual 4.3.2 Optional Board Terminal Description (Optional) Optional board is for keyfob and loudspeaker functions. Figure 4-2 Optional Board Terminal 4.3.3 General Wiring The general wiring of the lane control board.
  • Page 23 DS-K3G501LX Series Tripod Turnstile User Manual Figure 4-3 General Wiring of Pedestal with Power Switch Figure 4-4 General Wiring of Pedestal with Power Adapter Note You will need to prepare the 14AWG power cable to connect the AC power input to power ●...
  • Page 24: Chapter 5 Device Settings Via Button

    DS-K3G501LX Series Tripod Turnstile User Manual Chapter 5 Device Settings via Button You can configure the device via button on the main lane control board. Function Main Lane Control Board Only Working Mode keyfob Pairing Configure via button (refer to Pair Keyfob via...
  • Page 25: Configuration Via Button

    DS-K3G501LX Series Tripod Turnstile User Manual 5.1 Configuration via Button Button Description The buttons are on the lane control board. Figure 5-1 Button Exit Button Single press to open the gate from the entrance position. ● Double press to open the gate from the exit position.
  • Page 26 DS-K3G501LX Series Tripod Turnstile User Manual Button Configuration Procedure Figure 5-2 Procedure Steps: 1. Enter the configuration mode. The number of 1 will show up on the right side of the screen and the device is ready for configuration. 2. Press LEFT and RIGHT to set the configuration No. Press OK to enter the level-2 menu and view the parameters.
  • Page 27: Pair Keyfob Via Button

    DS-K3G501LX Series Tripod Turnstile User Manual 5.2 Pair Keyfob via Button Pair the keyfob to the device via button to open/close the barrier remotely. Before You Start Optional board is necessary for keyfob functions. ● Ask our technique supports or sales and purchase the keyfob.
  • Page 28: Appendix A. Button Configuration Description

    DS-K3G501LX Series Tripod Turnstile User Manual Appendix A. Button Configuration Description Refer to the table below for device configuration via button on the lane control board. Description Default Value Parameters Notes keyfob Pairing 1-Normal Mode 2-Pairing Mode Passing Mode 1-Both sides...
  • Page 29 DS-K3G501LX Series Tripod Turnstile User Manual Description Default Value Parameters Notes Enter Duration 5-5s,6-6s,7- 7s, ..., 60-60s Exit Duration 5-5s,6-6s,7- 7s, ..., 60-60s Volume 1-0,2-1,3-2,4- The device will be 3,5-4 muted when set to "1". Authenticated 1-Disable Unable to change...
  • Page 30 DS-K3G501LX Series Tripod Turnstile User Manual Description Default Value Parameters Notes Fire Protection 1-Remain Closed Type 2-Remain Open Restore to Default 1 1- Default The device will reboot. 2- Start...
  • Page 31: Appendix B. Event And Alarm Type

    DS-K3G501LX Series Tripod Turnstile User Manual Appendix B. Event and Alarm Type Event Alarm Type Passing Timeout None...
  • Page 32: Appendix C. Table Of Audio Index Related Content

    DS-K3G501LX Series Tripod Turnstile User Manual Appendix C. Table of Audio Index Related Content Index Content Authenticated. Card No. does not exist. Card No. and fingerprint mismatch. Passing timeout. No permissions. Authentication time out. Authentication failed. Expired card.
  • Page 33: Appendix D. Communication Matrix And Device Command

    Device Command Scan the following QR code to get the device common serial port commands. Note that the command list contains all commonly used serial ports commands for all Hikvision access control and video intercom devices. Figure D-2 Device Command...
  • Page 34 UD30764B...

Table of Contents