Page 1
如何配置 26 系列控制器连接 485 指纹读卡器 How to configure 26 series Access Controller to connect 485 Fingerprint Card Reader...
Page 2
Fingerprint Card Reader DS-K1201MF Magnetic Lock DS-k4H250D How to configure 26 series Access Controller to connect 485 Fingerprint Card Reader 1. Wring 1) Dial the 485 Fingerprint Card Reader and enable the first digit of the DIP Switch on the back of the 485 Fingerprint Card Reader.
Page 3
Add device and person to the IVMS-4200 platform 1) Connect the device to the Ethernet, search the device IP address via the SADP software. 2) Add the Access Controller and the Face Recognition Terminal to IVMS-4200 platform.
Page 4
3) Check the device status and make sure the card reader online. 4) Add person, via Face Recognition Terminal to add card and fingerprint.
Page 5
Apply to the device 1) Click Access Control-Access Group-Add,select person and Access Point, save then apply to the device.
Page 6
2) Click Access Control-Advanced Function-Authentication,then select the Authentication Mode as FP/ Card,and set the schedule.
Page 7
4. Test the function 1) Use fingerprint to test, than can open the Magnetic Lock. 2) Use card to test, than can open the Magnetic Lock.