How To Install The Outdoor Unit; Removing The Protective Spacer For Transportation; Installing The Outdoor Unit; Tubing Direction - Sanyo C2432A Installation Instructions Manual

6. How to Install the Outdoor Unit

6-1. Removing the Protective Spacer for
Transportation
Remove the packing skid from the bottom of unit and
then remove the plastic spacer used to secure the
compressor during transportation. (Fig. 6-1)
Place the unit on a level concrete pad, block or equal
and anchor.
Refer to Section 2. "Selecting the Installation Site".

6-2. Installing the Outdoor Unit

(1) Install blocks or a solid platform under the out-
door unit which provides a minimum height of
6 in. cm from ground level. (Fig. 6-2)
(2) The outdoor unit must be bolted down tightly to
the blocks or platform with 4 anchor bolts.

6-3. Tubing Direction

Tubing can be extended in 4 different directions as
shown in Fig. 6-3.
Service valves are housed inside the unit. To
access them, remove the access panel by remov-
ing the 3 attaching screws, then slide the panel
downward and pull it toward you.
If either rear, right or front tubing is needed, punch
out the knockout holes with a hammer or similar
tool.
After punching out the knockout holes, mount
plastic protectors on the tubing outlets. There
accessories are packed inside the unit and can be
accessed through the access panel.
Use tube benders to extend refrigerant tubing to the
outside.
Inter-unit
wiring outlets
Access panel
Front
Tubing
outlets
Fig. 6-3
Rear
Power
supply
wiring
outlets
Power
Right
supply line
Down
37
Compressor
Packing
skid
Fig. 6-1
6-11/16 26
Height :
Min: 6 in.
Fig. 6-2
Power supply line
1/2"
Inter-unit
power line
1007_C_I
S4179694
Plastic spacer
0496_C_I
4-21/64
Anchor
bolts
(not supplied)
Unit: inch
1168_C_I
Inter unit power line
1/2"