Using The Power Supply Hardwire Installation; Maintenance - Honeywell HCHD-310 Installation Manual

3. Feed the power supply wires through the knock out hole as shown in Figure 6. Connect to the terminal
block (i)the negative cable to the negative terminal (labeled N). Ii). The ground cable to the ground
terminal (labeled
4. Turn the Power button "ON". Determine whether you want the hand dryer set to hot air or cool air.
Important Note: Hot air setting will help dry hands quicker than cool dry setting.Refer to Figure 6.
5. Determine the mounting location. Refer to the Mounting the Unit for recommended height setting.
a. Use the hand dryer base as a template to mark the 4 drill hole locations.
b. Drill the 4 holes and insert plastic anchors.
c. Mount the hand dryer to the wall using the supplied screws as show in figure 3.
6. Connect the hand dryer to the nearest suitable distribution panel.
Ensure each hand dryer has its own dedicated circuit.
7. Place the stainless steel cover back on the hand dryer as shown in Figure 7.

MAINTENANCE

Exterior Maintenance
The exterior cover should be cleaned with a damp cloth to remove dust and surface dirt.Do not use
abrasive agents or solvents as it may permanently damage surface of cover.
Replacement of HEPA Filter
Excessive lint and dust build up inside the hand dyer can damage the motor and heating element.
Excessive build up can also increase the hand dyer's air temperature and risk injury to user. Light to
moderate use should require the HEPA filter to be changed about once a year. If the hand dryer is located
in a high traffic area, the HEPA filter should be replaced every 6 months.
). Iii). The positive cable to the positive terminal (labeled L).
6
7
7