Advertisement
Quick Links
User manual
1. Functional Description
CBAP210A is the module for BLE at embedded and Digital appliance applications. It is based on
Airoha AB1611 solution which comprises single chip with integrated BLE 5.0
2. Features
BLE (Version 5.0, only supports 1 Mbps)
Supports Adaptive Frequency Hopping
On chip support for serial peripheral interface (master and slave modes)
Compact dimension: 3 5 mm x 2 0 mm / H max: 4. 8 mm
Host Interfaces: UART Interface
RoHS compliant
PCB Pattern antenna, 5.60 dBi
Number of channels: 40 ch
Applicable test standard: FCC Part 15 Subpart C, 15.247
Supply voltage range
-
VCC 5V (4.5V ~12V)
Power Consumption
200mW
-
Advertisement
Related Manuals for Samsung CBAP210A
Summary of Contents for Samsung CBAP210A
- Page 1 User manual 1. Functional Description CBAP210A is the module for BLE at embedded and Digital appliance applications. It is based on Airoha AB1611 solution which comprises single chip with integrated BLE 5.0 2. Features BLE (Version 5.0, only supports 1 Mbps) ...
-
Page 2: Electrical Characteristics
3. Electrical Characteristics Absolute Maximum Ratings Symbol Parameter Min. Max. Unit DC supply voltage 12 V Power Consumption Parameter Conditions Min. Nom. Max. Unit Tx mode (Max current) 5V, 0dBm(+/-5dB) Tx Power TX Power Recommended Operating Conditions Symbol Parameter Conditions Min. - Page 3 4. RF Specifications All measurements are made under nominal supply voltage, room temperature, and conducted conditions at each antenna port except antenna. Parameter Conditions Typ. Unit Frequency Range 2402+K*2MHz (K=0~39) 2402 2480 Receiver PER ≤30.8% Sensitivity (PER) RSSI Value TCR Value (TCB RSSI Calibration Value) DUT RSSI Value (TRC Value-20) <...
- Page 4 FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
-
Page 5: Important Note
IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates this module. 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated into. -
Page 6: Label Of The End Product
(2) this device must accept any interference received, including interference that may cause undesired operation. LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX IC : 649E-CBAP210A ".