Specifications - Makita 4157KB Instruction Manual

ENGLISH (Original instructions)
1-1. Lever
2-1. Bevel scale plate
2-2. Knob
3-1. Base
3-2. Adjusting screw
4-1. Triangular rule
5-1. Notch
5-2. For 45 ﾟ bevel cuts
5-3. For straight cuts
6-1. Lock-off button

SPECIFICATIONS

Wheel diameter
Max. wheel thickness
Max. cutting capacities
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Do not use the tool upside down.
･
Do not use the abrasive cut-off wheel.
･
Do not use the saw blade and diamond
wheel with grooves and openings.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance
Directive,
Electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
Explanation of general view
6-2. Switch trigger
7-1. Dust box
7-2. Screw
8-1. Hex wrench
8-2. Shaft lock
9-1. Diamond wheel
9-2. Outer flange
9-3. Hex socket head bolt
9-4. Inner flange
10-1. Rip fence (Guide rule)
Model
90°
45°
)
0
Overall length
Net weight
Safety class
with household
of the
on Waste Electric
Equipment
END206-6
Intended use
The tool is intended for cutting in brick and concrete
without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations.
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains impedance
waste
equal or less than 0.31 Ohms it can be presumed that
there will be no negative effects. The mains socket used
European
for this device must be protected with a fuse or protective
and
circuit breaker having slow tripping characteristics.
and its
3
11-1. Dust cap
11-2. Rubber cap
11-3. Lever
12-1. Rear handle
12-2. Front grip
12-3. Base
13-1. Limit mark
14-1. Brush holder cap
14-2. Screwdriver
4157KB
180 mm
2.3 mm
58 mm
29 mm
-1
6,200 (min )
354 mm
5.6 kg
/II
an environmentally
recycling facility.
The operation of this
compatible
ENE024-1
ENF002-2
ENF100-1
device under