Table of Contents
Advertisement
RP 380 Press Tool
4.
Insert appropriate attachment.
5.
Fully close attachment mounting pin and rotate into locked position. Attachment mounting pin must be fully closed to
prevent tool damage during use.
6.
Inspect the gap between attachment and sleeve (See figure 6). Do not use tool if gap is greater than .394" (10 mm)
Excessive gap between the attachment and sleeve can allow access to the tool rollers during use. This can
WARNING
allow crushing injuries. Do not use Standard attachments with tool in Long configuration.
a. Fully
Attachment Mounting Pin
Closed
Figure 6 – Attachment Mounting Pin
Changing Tool Configuration (Long / Standard)
The RIDGID RP 380 Press Tool can be configured for use with RIDGID Standard or Long Series attachments (See Specifications
for more information). To convert between configurations:
1.
Remove any attachment from tool.
2.
With dry hands, insert a fully charged battery into tool. Depress ON/OFF button to turn tool ON.
3.
From Standard to Long - With hands clear of the rollers, depress the run switch to move the rollers forward
approximately 1/8" (3 mm). Rotate the sleeve to align the "Long" icon arrow with the housing arrow (Figure 7).
4.
From Long to Standard - With hands clear of the rollers, depress the run switch to move the rollers forward till the roller
housing is past the line on sleeve (see figure 7b). Rotate the sleeve to align the "Standard" icon arrow with the housing
arrow (Figure 7).
a. Standard Configuration
b.
(similar)
b. Long Configuration
Ridge Tool Company
Gap
Open
Fully
Attachment Mounting Pin
Open
Line on
Sleeve
Roller
Housing
11
Advertisement
Table of Contents
