Specifications (Need Information); Standard Equipment; Pre-Operation Inspection - RIDGID RP 380 Operator's Manual

RP 380 Press Tool
Figure 5– Tool Status Lights
Specifications (need information)
Attachments ................................... RIDGID Standard Series
Stroke Length .................................. Standard Configuration
Duty Cycle ....................................... 3 Press
Ram Force ...................................... 35 kN (7,875 lbs.)
Motor:
Voltage ............................. 18V DC
Amperage ......................... 27.2 Amp
Power ............................... 490 Watts
Battery ............................................ 18 V Li-Ion Rechargeable Battery Pack (RIDGID RB-1800 Series)
Operating Temperature .................. 15°F to 122°F (-10°C to 50°C)
Weight (no battery/attachment) .... 2.2 lbs. (4.9 Kg)
Dimensions ..................................... 20.1" × 3.35" × 12.6" (510 x 85 x 320 mm)
Klauke is registered trademark of Gustav Klauke GMBH.
Korea Dasung registered trademark? Open question for Wyatt Kilmartin
NOTICE The RP 380 Press Tool has a ram force of 35 kN. RIDGID Standard Series Press Tools and attachments are designed
for 32 kN ram force. Use of RIDGID Standard Series attachments with the RP 380 will significantly decrease attachment life as
compared to use with RIDGID Standard Series 32 kN Press Tools.

Standard Equipment

Refer to the RIDGID catalog for details on equipment supplied with specific tool catalog numbers.
NOTICE Selection of appropriate materials and joining methods is the responsibility of the system designer and/or installer.
Before any installation is attempted, careful evaluation of the specific service environment, including chemical environment
and service temperature, should be completed. Consult Press Fitting System manufacturer for selection information.

Pre-Operation Inspection

Yellow
1.57" (40 mm)
/min.
WARNING
Ridge Tool Company
Indicates service interval approaching. Starts at
18,000 cycles. Tool is usable, but tool will lock
after service interval (20,000 cycles).
Tool is locked. Tool has completed service
interval (20,000 cycles) and requires service
Tool has malfunctioned.
battery. If still ON, have tool serviced.
RIDGID Long Series / RIDGID Approved
Klauke® UAP4L compatible attachments (SBKUAP4 and
Actuator NW64-108 + KSP3LP Ring)
Korea Dasung SP-Joint compatible attachments
Long Configuration
3.94" (100 mm)
3 Press /min.
Remove and reinsert
9