Installation; Appropriate Installation Location - Beko BDIN Series Instructions Manual

4- Installation

Read the part first
"Safety regulations"! Installation
procedures should always be performed
by the manufacturer, authorized service
agent, or a qualified person designated by
the importer. To prepare the product for
use, make sure that the electricity, mains
water supply and drainage systems are
suitable before calling the authorized
service agent. If they are not, call a
qualified technician and plumber to check
the
necessary arrangements.
Site preparation and electrical,
tap water and wastewater
installations at the installation
site are the responsibility of
the customer.
Installation and electrical connections
must be carried out by the authorized
service agent. The manufacturer is
not liable for damage caused by
resulting from work by
unauthorized persons.
Before installation, check whether
the product has any defects. Do not
install the product if it is damaged.
Damaged products pose a risk to
your safety.
Make sure that the water supply and
drain hoses are not kinked, pinched or
pinched when the product is placed in
place after installation or cleaning.
The front of the appliance must not
be removed on free-standing
models or models that are
mounted under the worktop. Doing
so will void the warranty.
12/NL
When installing the product, take
care not to damage the floor, walls,
pipes, etc. Do not hold the product
by the door or panel to move it.
Suitable installation location
No lockable, sliding, or suspended
door should be installed in the
location where this product is
installed that would prevent the
door of the product from being fully
opened.
Make sure to choose a location
that will allow you to load and
unload the plates in a quick and
comfortable way.
†
Place the product on a solid and flat
floor that has sufficient bearing
capacity! The product must be placed
on a flat surface so that the door can
be closed smoothly and safely.
†
Do not install the product in places
where the temperature may drop below
0°C.
†
Place the product on a hard
surface. Do not place it on a thick
carpet or similar surfaces.
Do not place the product on the
power cord.
†
Make sure to choose a location
that will allow you to load and
unload the plates in a quick and
comfortable way.
†
Install the product in a place
close to the faucet and drain
hole. Select the installation
location considering that it will
not be changed after
connections are made.