Table of Contents
Advertisement
Adding switches
Purpose:
A wireless Zigbee Green Power (ZGP) switch can be added to a group or zone for lighting control.
How to:
• Choose "Switches" on the page of a group that needs to be configured, "+" and again "Switch". From the drop-down list of compliant switches select
the brand of switch you like to add and indicate whether you would like to add to a zone or to the whole group.
• Follow the switch commissioning instructions on available on our website. Please follow the instructions carefully, e.g. press the right buttons and don't do
pressing sequences too fast.
• Once commissioned, the app requests to test if the switch works correctly. Test the switch by making another button press, and once it works as expected,
press "Everything is fine".
• Please take note of the important remarks below.
Remarks:
• Add all luminaires in a group first and then add a switch. Switch binding mechanism is to
each node within the Zigbee group at the time of commissioning. If new nodes are added
after commissioning, switch binding does not take place.
• A switch can be added either to a group or to a zone. Once added to a zone, another
switch will need to follow the same choice i.e. either a group or a zone.
• Up to 5 switches can be added within a group. All switches attached within a group should
belong to a single brand. Combining switches from different brands is not recommended.
• In case switches are used for a group and for zones of that group, three things need to be
taken into account:
• 1. The switch of the group should be added first.
• 2. Only 2-button switches should be used for the group.
• 3. In the zones 4-button switches with scene setting can be used.
• It is recommended to use not more than one 4-button switch per zone.
• In case the switch is not detected during the commissioning procedure, please re-try.
21
Advertisement
Table of Contents
