Operating Precautions - Casio CSP-100/2875 Operation Manual

Table of Contents

Advertisement

Operation Guide CSP-100/2875

Operating Precautions

I This Pulse Monitor is not a precision medical instrument!
Note that this Pulse Monitor is intended for use as an exercise tool only.
It is not a precision medical instrument.
I Types of exercise
The Pulse Monitor is designed for use while walking. Strong impact and
vibration during running can make it impossible for the sensor to
correctly monitor your pulse.
I Use in cold weather
The Pulse Monitor detects the movement of blood in your earlobes to
determine your pulse rate. Very cold temperatures can cause poor blood
flow to your earlobes. When it is cold, massage your ears to stimulate
blood flow before attaching the clip.
I Ear clip position
The best position to wear the ear clip differs from person-to-person. If
you experience problems with getting a good pulse reading, try changing
the position of the ear clip on your ear until you find the best one.
I Removing the ear clip
When removing the ear clip from your earlobe, make sure you squeeze
the clip so it opens. Never pull on the wire to remove the ear clip. Doing
so can damage the wire.
I Pierced ears and earrings
Remove earrings before attaching the ear clip. If you have pierced ears,
avoid attaching the ear clip in the vicinity of an earring hole. Also, take
care that there is no hair between the ear clip surfaces and your earlobe.
This can cause incorrect measurement results.
I Use in the rain
Avoid using the Pulse Monitor in the rain. Exposure to water creates the
risk of malfunction.
I Storing the Pulse Monitor
Never store the Pulse Monitor where excessive force or pressure will be
applied to its arms. Such conditions can cause deformation of and
damage to the arms.
I Low battery indicator
Replace the battery as soon as possible after the low battery indicator
(
) appears.
I Care of the Pulse Monitor
Should the Pulse Monitor become dirty, wipe with a soft, dry cloth, or
with a cloth moistened in a solution of water and a mild neutral
detergent. Never use thinner, benzene, or other chemical, or any agent
that contains alcohol.
I Precautions when handling the arms
The arms of the Pulse Monitor are foldable.
Unfolded
Never apply undue force when folding or
Arms
unfolding the arms. Be especially careful
that you do not try to force the arms wider
than they are designed to unfold normally.
Applying too much force when folding or
unfolding the arms can damage them.
Folded
General Guide
Side Views
Left Arm
1 TUNE button
2 Ear clip holder
Earpiece (left)
4 Collar clip
Control Box Front View
6 MODE/SELECT button
Display
8 RADIO button
0 – button
Control Box Back View
1 TUNE button
Use this button to select a radio frequency.
2 Ear clip holder
Affix the ear clip here when you are not using it.
3 PULSE button
• Press this button to start a pulse measurement operation.
• Pressing this button during pulse measurement causes a simulated
human voice to announce your current pulse rate. The voice also
lets you know how you are doing in relation to the currently
selected exercise mode and your personal information settings.
4 Collar clip
Attaching the collar clip to your collar or somewhere else on your
clothing will secure the wire and keep it from swinging around as you
walk.
5 Ear clip
Attaching the ear clip to your ear lets the Pulse Monitor measure your
pulse rate.
6 MODE/SELECT button
Use this button to cycle between screens to view data or configure
settings.
7 STOP/RESET/ADJUST button
Press this button to stop an elapsed exercise time measurement
operation, and to reset the elapsed time display to zero.
8 RADIO button
• Press this button to turn the radio on and off.
• Holding down this button for about two seconds enters a mode for
registering radio frequencies in frequency memory for easy tuning.
9 POWER button
Hold down this button for about two seconds to turn on main power.
To turn off main power, hold down this button for about two seconds.
0 – button
Press this button to reduce the earpiece output volume.
A + button
Press this button to increase the earpiece output volume.
Right Arm
3 PULSE button
Earpiece (right)
Control box
5 Ear clip
7 STOP/RESET/ADJUST button
9 POWER button
A + button
Battery cover
2

Advertisement

Table of Contents
loading

Table of Contents