Troubleshooting - Casio CSP-100/2875 Operation Manual

Operation Guide CSP-100/2875

Troubleshooting

This section provides information about what you need to do when you
run into operational problems.
If this happens: Check this:
The voice error message Is the ear clip attached to your earlobe?
"Check ear clip." keeps Attach the ear clip securely to your ear.
sounding. Is the ear clip positioned correctly?
Change the position of the ear clip on
your earlobe.
Is it very cold?
Massage your ears to stimulate blood
flow.
Is the ear clip connected?
Make sure the ear clip connection is
secure.
Is the wire or ear clip damaged?
Replace the ear clip with a new one.
The voice error message Is the measured pulse within the
"Error." keeps sounding. measurable range?
Keep your pulse rate within the range of
30 to 199 beats per minute.
Is the ear clip attached securely to your
ear?
A loose or improperly fastened ear clip
can allow strong light to interfere with
proper pulse measurement. Make sure
the ear clip is attached correctly and
securely.
Are you in an area where there is electrical
noise?
Strong electrical noise can cause pulse
rate measurement errors. Avoid such
areas where electrical noise is being
generated.
The pulse value is Is your exercise causing severe vibration?
abnormal. The Pulse Monitor is designed for use
while walking. Strong impact and vibration
while running can make it impossible for
the sensor to correctly monitor your pulse.
The energy consumption Are you exercising at a sufficiently high
and body fat burned intensity?
values don't change. The energy consumption and fat burned
values produced by the Pulse Monitor will
not change unless you achieve a pulse
rate of at least 90 beats per minute. Try
walking faster to increase your pulse rate.
The energy consumption Are your personal information settings
and body fat burned correct?
values are abnormal. Proper measurement readings are not
possible unless your personal information
settings are correct. Check your settings
and make any changes that are
necessary.
The time in target range Are you exercising at an intensity that keeps
value does not change. your pulse within the target pulse range?
Try to keep the intensity of your exercise
at a level that keeps you within your target
pulse range.
I can't display Is an elapsed time operation in progress?
measurement memory Measurement memory contents cannot
contents. be displayed while the stopwatch is
performing an elapsed time operation.
Stop the elapsed time operation before
trying to view measurement memory
contents.
Important!
• Resetting the stopwatch to all zeros will
clear measurement memory contents.
10