Advertisement
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
MCS--4200/7200 Multi--Channel SATCOM System
(2) In the normal operation mode, member systems gather and store fault data when
equipment failure occurs during normal operation. This is typically performed by
continuous BIT and power--up BIT, with identified faults stored in the member
systems non--volatile memory (NVM). The CAIMS does not store fault information for
member systems, but the fault warning processor (FWP) supplies fault event data,
such as: flight leg, date, time, fault zone, and aircraft serial number information that is
stored with the fault in the member systems NVM.
(3) In the maintenance mode, the CAIMS is active and is called the on--board
maintenance system (CAIMS OMS). The CAIMS OMS is the ground maintenance
function and is accessible through communication link to a portable maintenance
access terminal (PMAT). With the PMAT, the aircraft maintenance crew can retrieve
stored fault data from a member system. For member systems, the CAIMS OMS
displays fault information, commands BITE test, and displays real--time data for
status displays, and commands the download of NVM fault data.
E. Level I Failure Messages and ATA Reference Numbers
(1) The Level I failure messages and ATA reference numbers that are available for
transmittal in the CFDS normal mode, for display in the CFDS interactive mode, and
for display on SCDU accessed maintenance pages are specified in the following
paragraphs for each CFDS type installed. Level I failure messages are intended for
use by line maintenance crews. Therefore, the failure messages are designed to be
LRU-based and only supply LRU-level identification.
(2) The Level 1 failure codes are two-digit hexadecimal numbers that define the LRU,
data communication bus, or miscellaneous interface signal where a failure, bus
inactivity, or signal error has been determined to have occurred. When multiple LRUs
are suspect, the most likely LRU is listed first followed by the next most likely LRU,
separated by a slash. The ATA number listed is for the first suspect LRU. Additional
text can be supplied at the end to help clarify the failure message.
• Table 6-18 describes the Level I failure messages and ATA reference numbers to
use for display on the SCDU accessed maintenance pages when the installed
CFDS type is a Boeing CMC. Also shown is the CMC message ID which is
displayed by the CMC in response to the Level I failure messages (refer to the
OEM's maintenance manual and fault isolation manual).
• Table 6-19 and Table 6-20 describe the Level I failure messages and ATA
reference numbers to use for transmittal in the CFDS normal mode, and the CFDS
interactive mode pages displayed when the installed CFDS type is an Airbus.
Table 6-19 is for the SDU (single configuration) or SDU No. 1 (dual configuration),
and Table 6-20 is for SDU No. 2 (dual configuration) as determined by the settings
of configuration pins TP12E and TP12F.
• Table 6-21 describes the Level I failure messages and ATA reference numbers to
use for transmittal in the CFDS normal mode, and the CFDS interactive mode
pages displayed when the installed CFDS type is a McDonnell Douglas.
• For CFDS type none, the Level I failure messages displayed on the SCDU
accessed maintenance pages are the same as those specified for Boeing (refer to
Table 6-18). However, no ATA reference numbers are displayed.
Honeywell International Inc. Do not copy without express permission of Honeywell.
23- -20- -35
Page 6--95
15 Jul 2006
Advertisement
