Operation - Breville AquaStation Chilled + Hot Instruction Book

Operation

OPERATING YOUR
AQUASTATION CHILLED + HOT
1. Ensure the water tank is in place and that
the water filter cartridge is correctly fitted
into position.
2. Plug into a 230/240V power outlet. The
unit will beep, the water droplet light
will flash 3 times, the LCD screen will
illuminate, and AMBIENT will display on
the LCD screen to indicate the unit is in
standby mode.
3. Remove the water tank and fill with cold tap
water to the MAX level. Never fill past the
MAX level.
4. Ensure the water tank is assembled to the
unit correctly and place a cup of choice onto
the drip tray, or alternatively, remove the
drip tray to accommodate large glasses.
NOTE
Always ensure the water tanks are filled to the
MAX level for optimum flow of water from the
spout. Ensure the water tanks are filled above
MIN water level, or as soon as the FILL TANK
alert appears on the LCD display.
If the water level falls below the MIN tank
marking, the water sensor will automatically
stop dispensing and FILL TANK will appear
on the screen.
Regularly check and discard any water that
might accumulate in the drip tray.
TURNING OFF THE AQUASTATION
Turn off at the power outlet.
IMPORTANT
Turning the unit off at the power outlet will
delete the 'last setting' memory function.
NOTE
Discard any filtered water that has been left
sitting for several days or more. This will
ensure you have cleaner, great-tasting water.
If your filter has been unused for a long period
of time, it is recommended to resoak the filter
for 10 minutes before use and clean the water
tanks as per the cleaning instructions found in
this book.
IMPORTANT
To prevent damage to the compressor and to
ensure maximum performance, place unit in an
upright position for 12 hours after transit.
NOTE
During the first-time usage only, when pouring
hot water, the first cup dispensed will be cold
water for boil dry protection and unit longevity
purposes. Discard the first cup of water poured.
STANDBY MODE
When the unit is plugged into the power outlet,
the water droplet light will flash 3 times, the
display screen will illuminate and AMBIENT
will appear on the display screen to indicate
the unit is ready for use.
The unit will automatically enter energy-saving
standby mode after 5 minutes if not used after
first cooling cycle. The water droplet light will
turn off when in standby mode.
To awaken the unit press any button or press/
turn the FUNCTION dial once; one long
beep will sound, the water droplet light will
illuminate white and flash rapidly 3 times to
indicate that the unit is ready to use.
17